X
PrevPrev Go to previous topic
NextNext Go to next topic
Last Post 01 Jan 2011 01:29 AM by  anon
Atmor.corr. using ENVI FLAASH on QB image
 1 Replies
Sort:
You are not authorized to post a reply.
Author Messages

anon



New Member


Posts:
New Member


--
01 Jan 2011 01:29 AM
    Currently im using the FLAASH on QB image for atmos.corr. However im getting either an error or a whole blank zero values results. My main purpose is to do the benthic mapping by using the QB image. The setting can be viewed as link below: http://i1127.photobucket.com/albums/l630/wiwi0169331253/setting.jpg The error report : http://i1127.photobucket.com/albums/l630/wiwi0169331253/error.jpg Any1 know the causes of these ?

    Deleted User



    New Member


    Posts:
    New Member


    --
    18 Jan 2011 10:51 AM
    I am wondering whether you have calibrated your QuickBird data using the ENVI tool under Basic Tools > Preprocessing > Calibration Utilities > QuickBird Radiance? If so, did you specify that the output should be in floating point? If so, then your data are in radiance units of mW) / (cm2 *nm*sr), which is what FLAASH expects. If not, then you will need to do that to get your data in the right units. If that's not the problem, let us know, and we might be able to come up with other ideas. That's the most common problem people run into hen using FLAASH. - Peg
    You are not authorized to post a reply.