X
PrevPrev Go to previous topic
NextNext Go to next topic
Last Post 22 Aug 2011 04:08 AM by  anon
layer stacking
 2 Replies
Sort:
You are not authorized to post a reply.
Author Messages

anon



New Member


Posts:
New Member


--
22 Aug 2011 04:08 AM
    I have been using ENVI for some time. Somehow I always used stacked images (done from other sources). Recently I tried to use layer stack option to stack Hyperion data. I must say, it it is very useful and time saving (took less than 2min to select and stack 242 bands). But the problem is, output is always in descending order; spectral plots starts from 2500 nm and ends at 400 nm (ideally it should be mirror image). I want this in ascending order. Reordering the bands during stacking is one option, but reordering 242 bands is a boring task. Can someone suggest a solution?

    MariM



    Veteran Member


    Posts:2396
    Veteran Member


    --
    22 Aug 2011 02:54 PM
    Unfortunately, there is no automated way to arrange the bands. When you import the data to layer stacking, you have the option at that point to order the bands manually.

    Deleted User



    New Member


    Posts:
    New Member


    --
    22 Aug 2011 08:30 PM
    Can't we change the logic for "pos" and "dims" in the "for" loops in ENVI_LAYER_STACKING_DOIT. (I'm just learning IDL!) I somehow bypassed the use of reorder tab. I renamed all the files in reverse order before using those (all 242, at the same time). Now everything is fine. Even don't need to reverse the sensor response function, which starts from 400 nm.
    You are not authorized to post a reply.