X
PrevPrev Go to previous topic
NextNext Go to next topic
Last Post 06 Jun 2014 01:21 PM by  anon
Hyperion Processing
 3 Replies
Sort:
You are not authorized to post a reply.
Author Messages

anon



New Member


Posts:
New Member


--
06 Jun 2014 01:21 PM
    When I use the Hyperion image with Radiometric Calibration Tool, with Flaash Setting, after completing calibration, a Pop up window appeared, and showing that "The following spectral value in the ENVI header is not consistent with the number of bands: bbl This value will be ignored." When I reopen the calibrated image then it also shows same. what is the problem. What value or File I have to use for "Radiance Scale Factor" at Flaash Please help me

    MariM



    Veteran Member


    Posts:2396
    Veteran Member


    --
    09 Jun 2014 08:08 AM
    Try using Edit ENVI Header-Edit Attributes->Bad Bands list. If any bands are set to 'bad' then set them all to 'on' and save the header. Yes, you can use the radiance image from FLAASH settings directly in Quac.

    Deleted User



    New Member


    Posts:
    New Member


    --
    19 Jun 2014 06:53 AM
    What Value or File I have to use for "Radiance Scale Factor" at Flaash Tool after the processing of a Hyperion image with Radiometric Calibration Tool, with Flaash Setting?

    Deleted User



    New Member


    Posts:
    New Member


    --
    25 Jun 2014 05:03 AM
    Thank You Sir. Please say somthing, how to Solve or minimise the vertical line effect in hyperion image Please help me,
    You are not authorized to post a reply.