X
PrevPrev Go to previous topic
NextNext Go to next topic
Last Post 06 May 2009 10:30 AM by  anon
ENVI-IDL-composition of processes
 1 Replies
Sort:
You are not authorized to post a reply.
Author Messages

anon



New Member


Posts:
New Member


--
06 May 2009 10:30 AM
    Normal 0 MicrosoftInternetExplorer4 Hi all, I cannot find information about how compose ENVI processes in a wizard process. For example I’ve a lot of ASTER Image to Ortorectify, correct for Athmospher effect using FLAASH and other ENVI process. Can I build a wizard that calls ENVI procedures automatically one after one. Where I can found this Information? Thank you Luca

    MariM



    Veteran Member


    Posts:2396
    Veteran Member


    --
    07 May 2009 10:50 AM
    There is no 'Wizard' interface to run batch processes as you describe.  In ENVI you would need to use the batch processing routines and write them in ENVI/IDL.  There are many examples in the ENVI help on how to write a batch routine and most processes in ENVI have a batch routine with example code.  However, I do not believe the orthorecification or FLAASH processing has a batch equivalent.  FLAASH in particular is difficult to run in batch mode because there are many parameters that must be set and customized for each file.  An alternative is to use the QUAC algorithm which does have a batch routine.  Batch orthorectification can be performed with the new Orthorectification module for ENVI 4.6.1.
    You are not authorized to post a reply.

    Forums Products ENVI