X
PrevPrev Go to previous topic
NextNext Go to next topic
Last Post 13 Dec 2013 06:13 AM by  anon
FLAASH for WV-2 data
 1 Replies
Sort:
You are not authorized to post a reply.
Author Messages

anon



New Member


Posts:
New Member


--
13 Dec 2013 06:13 AM
    Hi all, I'm having difficulties getting meaningful outputs from FLAASH for WorldView2 data. I have performed radiometric correction using the gain & offset values from the image header file and radiometric calibration to radiance (getting an output file with values in the order of 0.00X). When I run this image through FLAASH, specifying tropical atmospheric model and rural aerosol model, selecting NO for water and aerosol retrieval, I get an output image with negative values of several hundred when I would expect an output in the range 0-100. Any suggestions as to what is going wrong here?

    MariM



    Veteran Member


    Posts:2396
    Veteran Member


    --
    16 Dec 2013 07:28 AM
    It sounds like the radiometric calibration is not correct. Can you post the IMD file? Also, what did you use for an input scale factor for FLAASH?
    You are not authorized to post a reply.