ARCHIVE: IAS: Modify dialog does not launch if installing IAS over top of Viewer-only install
Anonym
If IAS is installed over top of a Viewer-only install, the Modify dialog of the installer does not appear and may cause confusion. This tip addresses CR #38735.
This situation will occur under the following circumstance:
- Install the Viewer through the Viewer-Only installer
- Restart the computer
- Install IAS 2.0 with the full 2.0 installer
- Click OK on the upgrade message
Result: The installer finishes the upgrade process.
Expected: The installer should launch the Modify dialog after finishing the upgrade process.