PrevPrev Go to previous topic
NextNext Go to next topic
Last Post 23 Jun 2021 06:36 AM by  maria.przylucka
Geocoding takes too long
 0 Replies
You are not authorized to post a reply.
Author Messages


New Member

New Member

23 Jun 2021 06:36 AM
    I try to perform DInSAR Dispalcement Workflow on two Sentinel-1 scenes. Before, during import, I used the shp file with the area of interest boundaries, so the scenes are cut to smaller area. All steps are performed fine. During GCP Selection, I added manualy around 40 points, evenly distributed throughout the image, omitting places of poor coherence. The workflow seems to stop moving forward during "Phase to Displacement Convertion". I see the process bar with "Geocoding [INTERF_out_cc]" line.
    Any idea what is happening? The problem repeats with differenc scenes. Each time it stops moving forward on Geocoding [INTERF_out_cc].
    You are not authorized to post a reply.